Game Card 3D (www.n3dstt.com) freezes my 11.3 N3DS

Discussion in '3DS - Flashcards & Custom Firmwares' started by opollon, Jun 19, 2017 at 6:05 PM.

  1. opollon
    OP

    opollon Advanced Member

    Newcomer
    56
    4
    Dec 27, 2016
    Australia
    hey have this card, but after inserting it, my N3DS with b9s 1.2 and luma 8 frezzes in the homemenu and no gamecard appears. in my unhacked o3ds, it appears in the homemenu but the card doest work since it isnt supported after 6.2 . Any ideas what i can do now?
     
  2. TheCyberQuake

    TheCyberQuake Certified Geek

    Member
    2,362
    1,309
    Dec 2, 2014
    United States
    Las Vegas, Nevada
    Cfw is your only choice to get the card working, it you don't already have it. Luckily with 11.3 it should be simple to get that set up with http://3ds.guide
     
  3. opollon
    OP

    opollon Advanced Member

    Newcomer
    56
    4
    Dec 27, 2016
    Australia
    I already have cfw
     
  4. TheCyberQuake

    TheCyberQuake Certified Geek

    Member
    2,362
    1,309
    Dec 2, 2014
    United States
    Las Vegas, Nevada
    Then I believe there is a dstt launcher made by apache thunder that may get your card to work. Other than that I wouldn't know and other users will have to help
     
  5. opollon
    OP

    opollon Advanced Member

    Newcomer
    56
    4
    Dec 27, 2016
    Australia
    The main problem is that my n3ds frezzes after putting the card in, so i have to turn it off. Other flashcards work fine
     
  6. SparrowPT

    SparrowPT Member

    Newcomer
    47
    6
    Jan 1, 2017
    Portugal
    Portugal
    I had this problem a few weeks ago with some DS games and also with my flashcart, and I ended up figuring out it was because of a problem with the cartridge reader. Basicly some of the pins were bent.
    If that's your case, try to lift the bent pins with a needle or something long but small, use a lantern to see properly ofc.
     
    Quantumcat and TheCyberQuake like this.
  7. TheCyberQuake

    TheCyberQuake Certified Geek

    Member
    2,362
    1,309
    Dec 2, 2014
    United States
    Las Vegas, Nevada
    Is it old or new? It may just be busted if the console freezes upon being inserted. I would say in either scenario anyway to just go with better card that's actually known and tested by the community, one like the r4i gold on nds-card.com
     
  8. opollon
    OP

    opollon Advanced Member

    Newcomer
    56
    4
    Dec 27, 2016
    Australia

    No pins are bent in my 3ds and other DS games still work, so i think the card is really busted
     
  9. SonicMC

    SonicMC GBAtemp Regular

    Member
    159
    46
    Dec 6, 2007
    United States
    I don't know what you have available; but I would try it in a regular ds or ds-lite for testing to make sure the card is still working.
    I would also try a different micro sd card for testing purposes too.

    if you can get it working on an older system. You can sometimes try different firmware updates. perhaps an older one would work better with luma; or even reflashing the latest firmware update could help if it didn't flash 100 percent correctly the first time.
     
  10. TheCyberQuake

    TheCyberQuake Certified Geek

    Member
    2,362
    1,309
    Dec 2, 2014
    United States
    Las Vegas, Nevada
    While I would agree with that in most cases, an outdated firmware or bad sd wouldn't cause the 3ds to freeze from merely inserting the card with just those problems. At most the card would not show up or not work when booted.