Question FW 1.0 Pegaswitch won't load using puyo puyo

Discussion in 'Switch - Exploits, Custom Firmwares & Soft Mods' started by Ryu009, Aug 9, 2018.

  1. Ryu009

    Ryu009 Member

    Mar 2, 2018
    United States
    Followed this guide to the t:
    Under Option i - Firmware Version 1.0.0 Step 10 - Launch the albumn applet

    I get error code 2162-0002
    "An error has occorred. Please hold the POWER button for 12 seconds and turn off the console"

    v1.0 of hbm was renamed to hbl.nsp and placed on the sd root
    I was able to see the pegaswitch logo screen after using puyo puyo tetris s
    I ran the evalfile usefulscripts/nsp.js

    Any suggestions? Thanks

  2. designgears

    designgears Advanced Member

    Aug 8, 2016
    United States
    Just use hekate or reinx from RCM mode, much easier than dealing with pegaswitch.

    edit: forgot reinx doesn't work on 1.0.0.


    Run thru that and get your backups and everything squared away. (expect to use around 30GB of space on your SD Card)

    From there, assuming you want to install NSPs or use SX OS to launch XCIs. Continue reading :D


    This will allow you to update to 5.1.0 without burning fuses (read: you can downgrade back to 1.0.0)

    Warning: Spoilers inside!

    if you want to install NSPs (eshop dumps, free), continue over to the ReiNX guide found here:

    Or you can use SX OS if you want to use XCIs (not free)
    Last edited by designgears, Aug 9, 2018