So I recently picked up an EZ Flash Jr., and it has been very reliable and easy to use, but the one thing I was kinda disappointed about was the lack of Rumble support. Naturally, I've been looking at potential ways I can add it myself.
According to Pan Docs, "On cartridges which feature a rumble motor, bit 3 of the RAM Bank register is connected to the Rumble circuitry instead of the RAM chip. Setting the bit to 1 enables the rumble motor and keeps it enabled until the bit is reset again."
Which is to say, one of the pins on the MBC5 directly controls whether or not the Rumble is active.
The EZ Flash Jr., however, looks nothing like the retail cartridges so I have no idea which EZ Flash Jr. pin controls the Rumble / RAM Bank Register.
Wondering if anyone can point me in the right direction.
According to Pan Docs, "On cartridges which feature a rumble motor, bit 3 of the RAM Bank register is connected to the Rumble circuitry instead of the RAM chip. Setting the bit to 1 enables the rumble motor and keeps it enabled until the bit is reset again."
Which is to say, one of the pins on the MBC5 directly controls whether or not the Rumble is active.
The EZ Flash Jr., however, looks nothing like the retail cartridges so I have no idea which EZ Flash Jr. pin controls the Rumble / RAM Bank Register.
Wondering if anyone can point me in the right direction.