Dismantling a MML

Discussion in 'Other Flashing Hardware & Software' started by om123, Aug 25, 2007.

Aug 25, 2007

Dismantling a MML by om123 at 3:12 AM (908 Views / 0 Likes) 4 replies

  1. om123
    OP

    Newcomer om123 Member

    Joined:
    May 22, 2007
    Messages:
    32
    Country:
    United States
    I have a max media launcher and i want to enable sleep mode by soldering pins 1 and 7, how do i open the cart without breaking it permanantly.
     
  2. paul1991

    Banned paul1991 Banned

    Joined:
    May 5, 2007
    Messages:
    680
    Country:
    United States
    I think that you have to solder the connections on your DS, not your passcard.
    I would just pick up a 3USD Dummy Card from DealExtreme.com or buy a real game.
     
  3. felix123

    Member felix123 GBAtemp Regular

    Joined:
    Dec 3, 2006
    Messages:
    261
    Country:
    New Zealand
    You can solder your NoPass or DS. It works the same.
     
  4. Eyedunno

    Member Eyedunno GBAtemp Regular

    Joined:
    Oct 20, 2007
    Messages:
    142
    Country:
    Japan
    Coming into this a little late, but looking at my own MML, it seems impossible to take apart, as it seems like they sealed one side of it somehow, either with glue or with heat. I'd say flash your DS instead and put an actual cart or dummy cart in (as was suggested before). Or you could swap in a cart without flashing, but that's kind of a pain to do every time.
     
  5. Darigon

    Newcomer Darigon Member

    Joined:
    Jun 2, 2007
    Messages:
    31
    Country:
    United States
    Get thumb tack and pop it in a crease it can get in then push it in more (don't hit the chip though) when its in enough slide the thumb tack around all of the mml and you should be able to pop it open [​IMG]
     

Share This Page