d2c wii

Discussion in 'Wii - Hacking' started by loresfx, May 14, 2008.

  1. loresfx
    OP

    loresfx Member

    Newcomer
    42
    0
    Sep 16, 2007
    United States
    Can someone give me some direction for d2c easy modding?
     
  2. James B.

    James B. GBAtemp Regular

    Member
    212
    0
    Oct 4, 2007
    United States
    USA
    1. Solder
    2. Close up wii
    3. ????
    4. PROFIT!
     
  3. muhsheesuh

    muhsheesuh Member

    Newcomer
    12
    0
    Apr 24, 2007
    United States
    usa
    I hear many of the new D2C's out are unmoddable currently. Check your serial number on the Wii serial tracker.
     
  4. loresfx
    OP

    loresfx Member

    Newcomer
    42
    0
    Sep 16, 2007
    United States
    Whats up with d2pro? this any good? If its only 9 wires thats not all that bad.

    http://www.d2pro.com/
     
  5. muhsheesuh

    muhsheesuh Member

    Newcomer
    12
    0
    Apr 24, 2007
    United States
    usa
    You can opt for the Wii-Clip + chip if you aren't confident at soldering.
    The D2Pro is for D2c consoles I believe with a new firmware update that cuts back from 15/13 wires to 9 wires. It still requires some soldering to the IC pins but they are not next to each other if I remember correctly, so soldering isn't too hard provided you have a bit of experience.
     
  6. loresfx
    OP

    loresfx Member

    Newcomer
    42
    0
    Sep 16, 2007
    United States
    so anything else out there other than d2pro?
     
  7. DrHectic

    DrHectic Advanced Member

    Newcomer
    88
    0
    Feb 2, 2008
    Sydney
    Wasabi is a low wire chip for d2c wiis. I have one - no problems so far.
     
  8. didineedthis

    didineedthis Member

    Newcomer
    49
    0
    Feb 25, 2008
    stick with the d2pro ,better support ,and a much better chip than the wasabi.

    didineedthis