Hacking Question Can't install NSP via USB after Trinket Switchme was installed

[nExNihilo]

Hi, all is in the title.

Since I have my chip into my switch, when I connect it to my computer, my switch is no longer detected.
But if I press the button on the trinket, I can put some file in it without any problem.

You can find my chip in attachment.

Any ideas ?

Thanks !

 

[dimitrij2k]

Just try these:

Start Goldleaf -> USB Mode -> Connect Switch - > Disconnect Switch -> Connect again

Try it 2-3 Times, sometime it help....

If not, build in a power switch to your Modchip. So that after Payload the Chip go off.

 

[nExNihilo]

Thanks ! Dat's works ! Its working better with the NSP file than the NRO