Adding a switch to a Wiikey

Discussion in 'Wii - Hacking' started by nhindian, Mar 8, 2008.

Mar 8, 2008

Adding a switch to a Wiikey by nhindian at 11:01 PM (1,362 Views / 0 Likes) 3 replies

  1. nhindian
    OP

    Newcomer nhindian Member

    Joined:
    Mar 4, 2008
    Messages:
    30
    Country:
    United States
    My Wiikey was installed by a modder and I assumed that it was installed via a long wire method. However, when I just opened up my Wii to install a switch to play Brawl tomorrow, I was disappointed to see that it was in fact a short wire install.

    I am wondering now if there is an easy way to install a switch with a short wire install or if I am screwed. I would prefer not to move it since I don't want to risk lifting a pad or breaking it.

    http://psx-scene.com/forums/attachme...g?d=1202451246

    If looking at that, there are only wires coming from the light blue contact and the dark blue and they are attached to the controller...

    Can I still install a switch and if so, how can I go about doing this? I really want to play Brawl tomorrow and I was all ready to put this switch in... thanks.
     
  2. nhindian
    OP

    Newcomer nhindian Member

    Joined:
    Mar 4, 2008
    Messages:
    30
    Country:
    United States
    anyone?
     
  3. Metalclay

    Newcomer Metalclay Member

    Joined:
    Jan 31, 2008
    Messages:
    30
    Country:
    United States
    your link is broken
     
  4. nhindian
    OP

    Newcomer nhindian Member

    Joined:
    Mar 4, 2008
    Messages:
    30
    Country:
    United States
    http://i272.photobucket.com/albums/jj184/r...z/wiikeyvcc.gif

    Well I tried to remove the wire that connects the gnd to the wii, but I tested it after I took it out and it still read burned games so I guess there's still a connection there from the solder I guess.

    Not really sure where to go from here since the solder is in that little hole.
     

Share This Page