Hi everyone I have a PS5 EDM-010 disk edition blue light comes on then console shuts down. I checked uart codes using BwE code reader and it's telling me DDR6 failure bank 1, 2, 3 and 8 reball or replace. My question is has anybody else seen multiple ram failures or could this be an APU problem...
Hi thanks for the reply. I replaced the XDPE chip last night no change still freezing will check the converter tonight, thanks again for your input much appreciated.
Hi everyone I have a ps5 EDM-033 which a friend gave me the problem is even if it is left on the home screen idling it freezes after 30 minutes with a loud buzz coming from the monitor speakers. There are also no input from the controller or the on off and eject buttons when it freezes, the only...
Yes I changed the southbridge a few hours ago and the console is acting exactly the same. I was just thinking that the southbridge is getting a signal from some where telling it to increase the duty cycle as the temperature increases.
Hi I checked a working consoles against the bad consoles PWM signal with my oscilloscope I attached screen shots of both. As you can see the non working fans waveform is more of a sawtooth wave than square. They have the same frequency the non working fans duty cycle is larger probably because...
I was thinking that might be the case but the temperature sensor is in the APU according to what I've read. I will check the wave form on a working console today because the bad consoles PWM waveform looks a bit odd. Thanks for your input much appreciated.
Thanks for checking that. I checked the PWM signal on my oscilloscope it's not showing a square wave it looks more of a curved sawtooth wave. The amplitude is about 550mV for about 4 or 5 seconds then drops to about 220 mV same as multimeter. I will check one of my other working console tomorrow...
Hi I understand that the PWM signal is a square wave and the duty cycle determins the percentage of time the voltage is on and off to the fan which controls the speed. My point is on a normal working console the voltage on the PWM pin is 550 mV when the fan is at idle speed where as on this...
Hi everyone I have a Ps5 edm-030, the console starts up normally fan spins for about 10 seconds then stops. The console stays on with output to tv. I checked the voltage on the PWM pin it is 550 mV for the first 10 seconds then drops to 240 mV. I can't figure out why, if anyone has any ideas I...
Hi everyone I brought a ps5 disk edition not working. The console turns on goes blue and to a white light I even get a message to plug in a controller and press the PS button, that stays on the screen for 6 or 7 seconds before it shuts off. I've noticed that if I turn it on a few times in...
Hi everyone I have EDM-020 with a 1.8v short which I tracked to the Wi-Fi module, I have ordered a new module the new one is a revision 1.0 where as the bad one on my board is a revision 1.3 does anyone think this will cause a problem. Pictures of the bad module and the replacement module are...
Hi I'm new to this forum or any forum for that matter hope I'm not braking any rules. I have a Ps5 board EDM-020 i had a short on the 1.8volt line at F7002 which I traced to the Wi-Fi module, problem is I was removing capacitors to track down the short and measuring the for my notes when the cap...
So, I wanted
to try the Ishiiruka fork of Dolphin since it could work on my pc, but since theres no official release of it I tried with project slippi's version of ishiiruka, but apparently it only works with smash melee