Separate names with a comma.
Thanks, but I forgot to mention that I need them in europe. Shipping from US is to expensive, since I need the 4 bottom screws only.
I misplaced the case screws of my GameCube and cannot find them anymore.
Does anyone know, which normal screws can be used as a...
When will this update being applied to the cartridge slot. During boot up of the console or sometime in the background?
But to dump my cartridges I need to disable nogc option, right?
I formatted the SD with FAT32. The corrupted data message still occurs. Simply performing the check fixes the issue :)
Yes, that´s a good point. So I can still dump a cartridge even though autonogc is enabled.
I used exFAT in the past to allow large filesizes (.nsp...
What is your opinon about disable autonogc? I don´t see the need for the possibility of an exploit on a lower firmware since my switch has been...
I copied Firmware 11.0.1 to the SD card and used Daybreak to update (preserve settings & FAT32 + exFAT). Update process succeeded.
Now I am...
Atmosphere is running now on my Switch. Thanks tons @Draxzelex and @Hayato213.
Tomorrow I will update the firmware to 11.0.1.
My fault, mate. You´re right. I checked the Hekate release .zip file, it does not include the .ini file. It´s an old file that exists on my sd...
I did not modified any files or binaries, just extracted the .zip files onto the SD card.
I downloaded both from their github repositories.
Thank you. Launch backups means installed .nsp files? I still did not get the difference between fss0 patches and fusee patches. It looks like,...
It looks like, that I could use some support.
I copied the latest Atmosphere files to the SD card and removed ReiNX files from it.
I can enter...
Thanks! I mentioned 10.1.0 with regard to ReiNX.
I will look for a guide to switch to Atmosphere and look into Daybreak.
I need to update the firmware of my Switch again. I did it before as described above.
Currently installed firmware:
I think I will send it to the Nintendo customer service.
I performed a factory reset. Afterwards basic setup of the console works until I try to add a new User. Then it results in error...
Thanks so far for your help and patience.
I removed all data from system memory, but that did not solve the problem.
Launching Mii Maker result...