Separate names with a comma.
I try to find "Trinket_Rebug_Joycon.uf2" file to enable SWITCHBOOT mode but links I found are disabled... @mattytrog Do you have alternative link...
OK it works ! [IMG] EDIT: My DAT- and DAT+ wires were reversed, now modchip detection and RCM boot are OK with SwitchMe. :)
It's ok the "orange damaged point" from my diagram was linked to GND for some reason (?!?). I scratched a bit and the link to the GND...
From your diagram, when I test the "yellow" track from USB-C, I have got GND (6th point from the right)... Do you have same ?
I have tried to use alternative DAT+ et DAT- pads (in back of the motherboard) but no RCM boot (even if the connection exists between damaged...
I recovered the console of a customer who damaged the motherboard of his Switch by wanting to weld a Trinket chip and he ripped 2 pellets (green...
Hi, Hardmod for 11.5.0 is not interesting because you can't downgrade from this firmware.
They are compatible HDMI port that fit perfectly. 2 versions available : V1 and V2. Depending your PS4 motherboard you can use one or the other. I...
Don't push the connector with the ribbon inserted ! Remove the ribbon than push otherwise you will stamp the contact surface on the ribbon tracks.
Could the console have taken lightning following a thunderstorm?
@loler55 Sorry but why just don't change HDMI port instead of your strange do-it-yourself ?!?
OK nevermind.
Yes I need to see the connector from above.
Another picture above please.
Pictures please.
I can do it. Take a look on the links from my signature.
This new type of brick is due to DSTWO PLUS use.
If you have just to change de L + ZL trigger buttons you could find the spare part from these link :...
France to France is also good my friend. ^^
If you have a popping sounds when you switch on the console this is due to the torn of the internal speaker ribbon. You need to change it because...
