Separate names with a comma.
Well you are supposed to press refresh and also change the spi backup.
Anyway you can't brick them with the toolkit in any way, even if you write...
Yeah the sd reader connector is not properly seated
No documentation other than explaining how it works and point you to the correct places.
But no time to do that today.
Also have in mind, because...
Yes it is possible to do that. You can have up to 4 sd card volumes (MBR constraints).
fatfs can be configured to identify these and access them...
I would go with the more expensive if money is not a problem.
The thing about sd cards is that they straight up lie to you about the speeds.
You can even use a UHS-II card, but it will capped at UHS-I speeds. (UHS-X is the bus type. U# is the UHS speed grade).
Switch in HOS is capable...
You can try, but doubt it will work.
As per spec, UHS bus is not compatible with 1 bit data bus.
On the other hand, after testing that, try to...
I'll leave that here:
Gratz for release!
The chip is the same. Not the board and pinout cfg. Plus any tweaks.
If only chip would matter, we would have L4T in switch since ever.
I also have that and I update my modchip. But no I can't do that.
It's a pain to maintain every single one. Best scenario is to learn how you can...
hekate v4.10.1 is released!
This is a hotfix version that rectifies the following:
Reverted 204MHz SD device clock
Some U1 sd cards with...
Strange setup, but whatever.
Do you have a discord?
If yes PM me.
Can you explain?
hekate v4.10 is released!
Full 8.0.0 support
Check OP or HERE for changelog or more..[/SIZE]
These addresses are not over-writable by normal SPI cmd. Your offsets are the firmware. Color info only resides in x6000 bank.
As for generally...
You probably updated while in CFW. Atmo has protection for that and your autorcm was not lost. And that's why you still have 8 fuses.
Or you had...
They seem normal.
The capacity now/full/design is normal to be like this, because you removed the battery and haven't booted into HOS to restore...
Just a photo of that screen with the battery info is enough.
Well there were reports of strange outlets killing switches or emmcs.
Yeah send a battery info.
As for the pcb there, such little scratches ain't...