Separate names with a comma.
Checked m92t36 just to make sure, I get 3.3v output while charging on pin 5 so that chip seems to pass.
Which pins am I needing to check on BQ24193?
Ok thanks - I will check bq24193 in the morning and report back. Thanks for your help so far, much appreciated.
Ok so, with a fully charged battery, it still reads 0.0% charged.
If i run reset fuel gauge, it throws an error "You need a fully charged battery...
Thanks, I'll let you know how it goes.
Mattytrog, I just rebooted the switch and ran Battery Info again.
This time we have some populated fuel gauge registers, but it still seems...
I see. So basically the fuel gauge IC is not getting/sending the correct information, so the system assumes the battery is flat / not installed?
edit: delete, double post.
Ah... right, so MAX17050 is likely fault? Needs replacing?
Ok, so I should inspect BQ24193?
Also edited my post above, worth noting in Hekate, it shows 0.0% battery (1280mV) at the bottom.
I checked with my customer and yes, the switch has never been messed with.
Battery readings are stable, ~4.18v on a full charge. I also powered...
Checking the fuse count, it shows that 9 fuses are burnt.
Hey guys, I recently repaired a charge port on a Nintendo switch.
After the console is now powering on, it will show the Nintendo logo for ~2...