Comments on Profile Post by Jiehfeng

  1. Extrasklep
    Extrasklep
    place a block above it?
    Aug 13, 2019
  2. Jiehfeng
    Jiehfeng
    I'm trying to get it to not go down, not not up. Even so that won't work, only enemies collied from above as far as I've tested, and they all make it fall all the way.
    Aug 13, 2019
  3. Extrasklep
    Extrasklep
    what if you place a block on both sides?
    Aug 13, 2019
  4. Jiehfeng
    Jiehfeng
    As in one block under it on either sides? Doubt it, but I'll give it a go later, thanks. If it does work then the seesaw wouldn't move, so I still haven't achieved what I want.
    Aug 13, 2019
  5. Extrasklep
    Extrasklep
    One block above on both sides
    Aug 13, 2019
  6. Extrasklep
    Extrasklep
    I tried placing blocks above but it seems to ignore them too but I found another way
    Place some enemy or a pow block on a cloud and put a block above it
    Aug 13, 2019
    Jiehfeng likes this.
  7. Jiehfeng
    Jiehfeng
    And this set will be under the seesaw? Cause again I want to stop it from going down to the right.
    Aug 13, 2019
  8. Extrasklep
    Extrasklep
    It only works above
    I don't know if there's a way to block it from below
    Aug 13, 2019
  9. Jiehfeng
    Jiehfeng
    Welp, this is what I fear is not doable. Above, there are many ways. A powerup is a simple one.
    Aug 13, 2019
  10. Extrasklep
    Extrasklep
    You can put some one way things on the right side but it only blocks the player and enemies and won't stop the seesaw from tilting right after being tilted left
    Aug 13, 2019
  11. Jiehfeng
    Jiehfeng
    Well, I'll experiment further and see if I can make something with a similar result I have in mind. Thanks for helping.
    Aug 13, 2019
  12. Jacklack3
    Jacklack3
    i think seesaws go through grounds and stuff. so only the objects on each side will collide. you could use on or off switches to hold an item down and then toggle the switch to release it.
    Aug 13, 2019
  13. Jiehfeng
    Jiehfeng
    Hmm good idea, I'll try that.
    Aug 13, 2019
    Jacklack3 likes this.