Hello guys, this is my first post here! I just got a MIG Switch card out of curiosity and I was tinkering with it. For those who don't know, it's used by placing XCI dumps as well as other game specific bin files in the sd card of the MIG Switch, and are obtained from the original cartridge by using an app like nxdumptool. Two of these bin files are mandatory to get the game to boot: Initial Data.bin and Certificate.bin. They stay the same for every cartridge of a specific game. Now, if you want to use an XCI dump from a shady website it's impossible to get it to work without those files. By using the Certificate.bin from another game it has no problem, but this does not count for the Initial Data.bin. So I looked for a way to obtain this Initial Data from an XCI file and read a bit of the XCI file documentation from switchbrew dot org. Here's what I understood so far: The Switch checks if the cartridge is valid by doing a challenge–response authentication on the Initial Data. The Package ID is contained both on the XCI and the Initial Data, on positions 0x110 and 0x0 respectively. The Initial Data hash is on the XCI at position 0x160. It is calculated by doing a SHA-256 hash on the full Initial Data content. So I was wondering, is there a way to to construct a functional Initial Data file starting from an XCI dump? I also tried a reverse approach by editing the Package ID in the Initial Data from another game, generating the Initial Data hash and putting it in the XCI file but is not enough to get the Switch believe it's a real game. Sorry if this may seem stupid but let me know what you think.

mig switch not working/updating??

stickybit · 2024-03-28T19:59:51+00:00

just got my mig switch and followed instructions to the T to update it and all im getting is a red light and then a message saying cart not recognised, all im trying to do is update it to the latest firmware, it says it should flash blue when...

Hardware Error code 2002-3580,is it fixable?

Thread starter lpoolm
Start date Jul 23, 2021
Views 6,159
Replies 3

lpoolm

Well-Known Member

Member

Level 11

Jul 23, 2021

Hi, I can't find much on this error other then I don't think I've seen a fix.
The console starts works for 30sec - 1 min then error message comes on. Only option is turn it off and on.
Anyone got any ideas on what I could try?
Thanks

thesjaakspoiler

Well-Known Member

Member

Level 8

Aug 2, 2021

Afaik it's a data corruption error.
Some people mention a factory reset but most people end up sending their Switch back to Nintendo.
It's unclear whether replacing the NAND itself will fix it as some people mention that it might also be related to the DRAM memory.
If it happens during playing a game, just delete the game and reinstall it in the hope that the Switch marks the bad NAND memory.

lpoolm

Well-Known Member

Member

Level 11

Aug 2, 2021

Thanks for the reply, unfortunately it freezes after around 30 seconds so can't set it up any further to do any more tests /updates.
I ended up sending to Nintendo but £150 to repair obviously not worth it.
Will send to ebay!