Hello guys, this is my first post here! I just got a MIG Switch card out of curiosity and I was tinkering with it. For those who don't know, it's used by placing XCI dumps as well as other game specific bin files in the sd card of the MIG Switch, and are obtained from the original cartridge by using an app like nxdumptool. Two of these bin files are mandatory to get the game to boot: Initial Data.bin and Certificate.bin. They stay the same for every cartridge of a specific game. Now, if you want to use an XCI dump from a shady website it's impossible to get it to work without those files. By using the Certificate.bin from another game it has no problem, but this does not count for the Initial Data.bin. So I looked for a way to obtain this Initial Data from an XCI file and read a bit of the XCI file documentation from switchbrew dot org. Here's what I understood so far: The Switch checks if the cartridge is valid by doing a challenge–response authentication on the Initial Data. The Package ID is contained both on the XCI and the Initial Data, on positions 0x110 and 0x0 respectively. The Initial Data hash is on the XCI at position 0x160. It is calculated by doing a SHA-256 hash on the full Initial Data content. So I was wondering, is there a way to to construct a functional Initial Data file starting from an XCI dump? I also tried a reverse approach by editing the Package ID in the Initial Data from another game, generating the Initial Data hash and putting it in the XCI file but is not enough to get the Switch believe it's a real game. Sorry if this may seem stupid but let me know what you think.

mig switch not working/updating??

stickybit · 2024-03-28T19:59:51+00:00

just got my mig switch and followed instructions to the T to update it and all im getting is a red light and then a message saying cart not recognised, all im trying to do is update it to the latest firmware, it says it should flash blue when...

Hacking Question Problem, with partitions, setting up Atmosphere

Thread starter GenetixUTD
Start date Jun 22, 2021
Views 2,128
Replies 2

GenetixUTD

Member

Newcomer

Level 1

Jun 22, 2021

I'm having a problem setting up my SD card with Atmosphere. I've formatted my SD card with TegraExplorer, and I'm ready to copy my Atmosphere files to my SD Card. The prompt comes up to tell me to format the drive, which I cancel, but then get the error as follows;

Have I perhaps done something wrong? I cannot access my SD card to move the files over like this.

Dust2dust

Well-Known Member

Member

Level 14

Jun 22, 2021

I never used TegraExplorer, but I guess it formats in FAT32. Are you using Windows? Maybe try formatting again from Windows (still in FAT32) and see if it works.

GenetixUTD

Member

Newcomer

Level 1

Jun 22, 2021

I never used TegraExplorer, but I guess it formats in FAT32. Are you using Windows? Maybe try formatting again from Windows (still in FAT32) and see if it works.

Ah! I reformatted the drive to FAT32 using a partition manager. It seems the drive actually formatted to NTFS rather than FAT32 the first time.

Reactions: Dust2dust