Don't know if anyone can suggest a way forward with this.....
Basically I've been using SX Pro with my Switch. I was on firmware 9.0.1. Took a copy of my Nand before doing anything with SX Pro
I later updated to firmware 10.2 using ChoiDujourNXv102. But didn't take a Nand backup after this.
Recently my switch failed, and both the PI3USB and M92T36 had blown. These were replaced, and the v6 Nand was restored with SX Pro
However the Switch will not boot normally. I just get a black screen, and no Ninty logo. No problem injecting a payload
I think I made a mistake and burnt fuses when I did the upgrade because I can see the fusecheck says 13.
I assume my problem is because I have a fuse mismatch, but even after I boot stock mode in Hekate which is meant to bypass the fuse check I get the same issue
Are there any options to fix this? I did spot a webpage that talks about upgradng the firmware via a PC and the PC version of ChoiDujour. Any thoughts?
Thanks!
Basically I've been using SX Pro with my Switch. I was on firmware 9.0.1. Took a copy of my Nand before doing anything with SX Pro
I later updated to firmware 10.2 using ChoiDujourNXv102. But didn't take a Nand backup after this.
Recently my switch failed, and both the PI3USB and M92T36 had blown. These were replaced, and the v6 Nand was restored with SX Pro
However the Switch will not boot normally. I just get a black screen, and no Ninty logo. No problem injecting a payload
I think I made a mistake and burnt fuses when I did the upgrade because I can see the fusecheck says 13.
I assume my problem is because I have a fuse mismatch, but even after I boot stock mode in Hekate which is meant to bypass the fuse check I get the same issue
Are there any options to fix this? I did spot a webpage that talks about upgradng the firmware via a PC and the PC version of ChoiDujour. Any thoughts?
Thanks!
Last edited by Purity,