Hi all,
The other night when launching Tinfoil I wasn't paying attention properly and when it asked me to update I just hit yes. This immediatelty shut down my Switch and spawned this error meesage on my screen - "Fatal error: NXBOOT unable to identify package 1, press power button to reboot". Hitting the powerbutton just sent me back to this this error message.
I tried to reset the Switch with the long press reset which did stop the above error message appearing but now I can't even lauch into the standard switch fireware, nevermind the CFW. I think I might have updated the fireware by mistake. I appreciate this is my first post here, but I've looked everywhere and this community seems to have loads of sollutions for problems, so I was hoping someone could get me out of a bind here and help because I'm at a complete loss on what to do
When I plug the Switch into the PC it does find it, I get the noise from the PC to say it's plugged in and Tegra sees it.
But when I try to load the payload with Tegra I just get this error
This is what the files look like on my Switch SD card. Am I missing something from here?
(inside the "switch" folder)
I also have this backup on PC I did with the guide I used (which I can't use to restore this because it requires using the payload). Can I do anything with these backups?
Any help would be greatly appreciated because right now my Switch is bascially bricked.
The other night when launching Tinfoil I wasn't paying attention properly and when it asked me to update I just hit yes. This immediatelty shut down my Switch and spawned this error meesage on my screen - "Fatal error: NXBOOT unable to identify package 1, press power button to reboot". Hitting the powerbutton just sent me back to this this error message.
I tried to reset the Switch with the long press reset which did stop the above error message appearing but now I can't even lauch into the standard switch fireware, nevermind the CFW. I think I might have updated the fireware by mistake. I appreciate this is my first post here, but I've looked everywhere and this community seems to have loads of sollutions for problems, so I was hoping someone could get me out of a bind here and help because I'm at a complete loss on what to do
When I plug the Switch into the PC it does find it, I get the noise from the PC to say it's plugged in and Tegra sees it.
But when I try to load the payload with Tegra I just get this error
This is what the files look like on my Switch SD card. Am I missing something from here?
(inside the "switch" folder)
I also have this backup on PC I did with the guide I used (which I can't use to restore this because it requires using the payload). Can I do anything with these backups?
Any help would be greatly appreciated because right now my Switch is bascially bricked.