I inherited an extra Corona 360, so I thought I'd challenge myself and see if I could hack the thing. I was able to install the Nand reader and read the nand, and create and write the ECC file. I then hooked up the x360ace v5. As best as I can tell, I got the soldering done without bridging anything, but when I attempted to turn things on, I'm getting no response or loading screen.
From what I understood about v5, it came preloaded, so I didn't think there was anything I needed to do after hooking up the v5. Did I miss a step after I installed the glitch chip? Is there anything I can to check if I did the soldering right, or if the chip is working?
Thanks for any advice. I figured there was a risk I might sacrifice this box to improving my soldering skills, but I don't want to give up quite yet!
From what I understood about v5, it came preloaded, so I didn't think there was anything I needed to do after hooking up the v5. Did I miss a step after I installed the glitch chip? Is there anything I can to check if I did the soldering right, or if the chip is working?
Thanks for any advice. I figured there was a risk I might sacrifice this box to improving my soldering skills, but I don't want to give up quite yet!