D
Deleted User
Guest
There are clean installs and moderfucker Clean , thats a new Level , Amazing job and great pics
Thank You Bruddah!
There are clean installs and moderfucker Clean , thats a new Level , Amazing job and great pics
Just search AliExpress. I searched for "SX Lite" and the first post was a seller.Hello everyone!!
I am desperately looking for a link to buy a SX lite chip. Is there a charitable soul that can help me plz ? Every link I found is already dead...
Hello everyone!!
I am desperately looking for a link to buy a SX lite chip. Is there a charitable soul that can help me plz ? Every link I found is already dead...
3 days 1 person has had a green light switch lite, never go past the splash screen would boot ofw fine disconnected
folks this is what happens when you cold solder, and bridge your connections not even ground soldered
flux is important for this also a higher temp is anything under 320c and your gonna rip pads etc
admittedly sp1 and sp2 are passable
I'm using the 340-360 mark but my ts100 could do with a calibrationWhat temp you recommend from your experience, ill be doing around 40 next week and the week after.
I jtagged a shit load of xbox 360s fat/slim, was a while back but helps my cause
Used to drill the damm Dvd Drive ic to unlock it
look ma no anchors
look ma no anchors
so do you have any ics of my install or are these pics of my install? i sent my yellow switch lite
also i thought you needed to solder the anchors or at least one to ground the chip i guess connecting them serves no electrical function at then?
It's a 10w chip. You're going overboard with what is needed to cool an X1. People can use what they have laying around or buy whatever is cheapest (as long as it's non conductive). Unless they are also PC enthusiast, then they already have 3 tubes of what they like already.to solve everyone questions about thermal paste. ditch the mx series for either a ic diamond graphite pad, or thermal grizzly thermal pads or thermal paste. best in the business.
Yes, let me just slap some old crappy paste on my x1 and call it a day. Great solution you got thereIt's a 10w chip. You're going overboard with what is needed to cool an X1. People can use what they have laying around or buy whatever is cheapest (as long as it's non conductive). Unless they are also PC enthusiast, then they already have 3 tubes of what they like already.
Sent from my ONEPLUS A6013 using Tapatalk
It's guaranteed to be better than the stuff Nintendo uses that was bought in extreme bulk. Where there's actual profits to be had by using the cheapest stuff when selling millions of units.Yes, let me just slap some old crappy paste on my x1 and call it a day. Great solution you got there
Question for anyone who has one installed.
Is your battery draining faster, even while turned off? I'm assuming this is something related to the mod chip thats unavoidable but want to make sure lol