Suggestion
Is there a way to stop hardware checks for Charging IC M92T36 & Bluetooth NIC IC BCM4356 on NX boot ?
I noticed when this two IC's has a hardware issue (maybe cold solder joint) the Switch will stuck on "Switch" boot logo. Same with "Orange Screen" -> Issue BCM4356.
But very intressting is on this thing and realize with BCM4356. If the battery is lower as 10% (power save mode) the Switch will continues loading and didn't stuck.
Therefore the question to turn HW checks off and I know at the end (or not?) is the IC damaged but with this you can boot and maybe retrieve datas.
Note: If you're NSW will not come back from standby (0xE401 Invalid handle) it will also help with low <10% battery power to work back again! Try it...
Is there a way to stop hardware checks for Charging IC M92T36 & Bluetooth NIC IC BCM4356 on NX boot ?
I noticed when this two IC's has a hardware issue (maybe cold solder joint) the Switch will stuck on "Switch" boot logo. Same with "Orange Screen" -> Issue BCM4356.
But very intressting is on this thing and realize with BCM4356. If the battery is lower as 10% (power save mode) the Switch will continues loading and didn't stuck.
Therefore the question to turn HW checks off and I know at the end (or not?) is the IC damaged but with this you can boot and maybe retrieve datas.
Note: If you're NSW will not come back from standby (0xE401 Invalid handle) it will also help with low <10% battery power to work back again! Try it...
Last edited by rogras,
