Homebrew Update 11.12 and Homebrew
- Thread starter GalladeGuy
- Start date
- Views 18,847
- Replies 49
- Likes 9
Hi, guys.
About B9STool and Seedminer based-on methods (like Bannerbomb3, Fredminer, etc.), is there any confirmation about they are compatables with the latest FW version already? Or do we have to stay some confirmation yet?
That's because there is available a new version of B9STool on GitHub, but I don't see people that have tested and confirmed.
Thanks in advance, and sorry for my bad english
About B9STool and Seedminer based-on methods (like Bannerbomb3, Fredminer, etc.), is there any confirmation about they are compatables with the latest FW version already? Or do we have to stay some confirmation yet?
That's because there is available a new version of B9STool on GitHub, but I don't see people that have tested and confirmed.
Thanks in advance, and sorry for my bad english
We've updated both our consoles to 11.12 (both USA NTSC units) everything running as intended so far
D
Deleted-236924
Guest
I am on v9.1
--------------------- MERGED ---------------------------
it stopped working after I updated
its not really killed off. Its just the devs need to get the firmware update done to allow it to work again. This has been a common thing each update.
Yes, just be sure to adapt the current guides in these 2 ways:
1- replace frogtool with this one: https://gbatemp.net/threads/the-nin...orm-of-v11-12-0-44.551558/page-4#post-8849161
2- be absolutely sure to replace b9stool with the one designed for 11.12 kernels
Similar threads
-
-
-
@
SylverReZ:
If you want a good system to port it to, at least have a good programmer and knowledge.+1 -
-
-
-
@
Psionic Roshambo:
I didn't know they made an MSU cart for the Genesis.... I knew about the SNES one and the library for that is rather large but the Genesis one has very few games+1 -
-
@
SylverReZ:
An FPGA could probably replicate the chip's functionality without buying donor parts.+1
-
-
-
@
Psionic Roshambo:
Like not emulating the entire SNES but just a loader and the enhancement chips perhaps even slightly overclocked like FX-2
-
-
-
-
-
-
-
@
SylverReZ:
@Psionic Roshambo, The Doom NES cartridges, a few batches were made. One was given to AVGN as seen in his Doom video.+1
-
-
@
Sicklyboy:
I finally modeled and 3d printed the new HDD cages I need in order to build my 2nd NAS. Original ones don't fit the mounting holes on the hdds I'm using. Been sitting on this project for over 2 years smfh -
-
@
Sicklyboy:
I'm finally gonna get this NAS racked and powered on tonight, install truenas core, and burn the disks in with badblocks
-
@
Sicklyboy:
Also another 70TB going in the front mount drive bays of this server. 182tb raw, going to probably use a zfs RAID-Z3 for 3 parity disks, so 140TB usable
-
@
Sicklyboy:
I could claw back 14tb by only doing 2 parity disks but I feel like with 13 disks in the RAID I'd be kind of pushing my luck on rebuild time if I encounter a disk failure
