Hacking Question Black screen after booting hectate help please

Haaris · Jul 13, 2019

So switch serial is the possibly patched one, but i did test fusee on it and it said it was successful although never showed anything on screen.

So i went ahead to launch cfw it says smashing the stacks etc but it just still has black screen, i have updated fw for exfat cat already, and i have also reformated the sd card and still the same thing.
Anyone help please?
Thanks

BryBread · Jul 13, 2019

Format your SD card for FAT32; that has better compatibility and less chance of corruption. Try using AtlasNX, as that has everything preconfigured. Then report back if you still have a black screen. Chances are you're just using an outdated version of atmosphere/sept for the system version your switch is on.

https://switch.homebrew.guide

Haaris · Jul 15, 2019

BryBread said:
Format your SD card for FAT32; that has better compatibility and less chance of corruption. Try using AtlasNX, as that has everything preconfigured. Then report back if you still have a black screen. Chances are you're just using an outdated version of atmosphere/sept for the system version your switch is on.

https://switch.homebrew.guide

I already followed everything on that website using fusee-gelee method

Resaec · Jul 15, 2019

That sounds like a patched unit to me.
You should use TegraRCMGUI. It will help you setup drivers, tell you when the Switch is detected in RCM and push the payload reliably.
You should push Hekate to see if your Switch is patched or not. If Hekate does not show up your Switch is patched.

Hacking Question Black screen after booting hectate help please

Well-Known Member

Member

Well-Known Member

Well-Known Member

Similar threads

Popular threads in this forum