I am booting with a jig to get into RCM after which I run the ReiNX payload. Everytime I want to put files on my SD card I switch off the device, take the sd card out and put new files on it.
Once done I put the jig in again to get into RCM for loading the ReiNX payload.
I read some information about fuses and I wonder if this method burns fuses, which may cause trouble at a later time. Are my worries valid and should I adjust the above method or don't I have to worry at all ?
Once done I put the jig in again to get into RCM for loading the ReiNX payload.
I read some information about fuses and I wonder if this method burns fuses, which may cause trouble at a later time. Are my worries valid and should I adjust the above method or don't I have to worry at all ?