Thanks for the input!I agree, I'd rather see someone using foil than the paperclip. Paper clip is a great way to damage the pins if it was cut poorly or someone pushes hard.
Thanks for the input!I agree, I'd rather see someone using foil than the paperclip. Paper clip is a great way to damage the pins if it was cut poorly or someone pushes hard.
Because it comes bundled with the pins and ribbon!How would I use a replacement joy-con rail as a "jig"?
How would I use a replacement joy-con rail as a "jig"?
Actually, I wrote that post before that thread was created. The safest way will always be internally soldering the JoyCon.I totally agree with you. I still like the magnetic reed switch best, but for someone who can't/won't solder, the kinked jig is best for sure.
the horror story you mention is exactly what I imagine a ton of people doing out of ignorance.
--------------------- MERGED ---------------------------
No, this is the best method.
https://gbatemp.net/threads/tutorial-another-magnetic-reed-switch-rcm-installation.505438/
yeah I'm a little biased.
--------------------- MERGED ---------------------------
That's a really good idea too. Not as good as the mag switch but a lot better than a jig.
--------------------- MERGED ---------------------------
That's not very helpful. That's like telling someone "don't screw up". People who don't know how to do THIS stuff don't know how to be careful. Try to post things that are actually useful in the future.
Yeah I use a reed switch in mine. But for those who don't want to open up their joycon the joycon rail replacement option is probably the best jig method and wont cause damage to the switch pinsThat's a really good idea too. Not as good as the mag switch but a lot better than a jig.
Meh, once CFW can be installed we only need it for rare occasions anyway.
how do i do that?you would connect pins 1 and 10 on the replacement joycon rail. Then it becomes a jig.
how do i do that?
Why not Jig once, then AutoRCM? Seems the way to go for me, you'll not damage your device, and will not haave to open your joycon/but a new one.
wire and solder on pins 1 and 10 of the solder points on the connector (inside part of rail)
If you don't understand you should read some joycon teardowns.
That sounds difficult and/or expensive. Are there any easier options?
Magnetic contraption? unneded, there are magnetic switchs, they are called "reed switch"Probably be a good idea to open the right Joycon and add a little switch in there (a switch on your Switch, ha).
Or a magnetic contraption sort of thing that when you place a magnet near it, it lifts a piece of metal and closes the circuit.
You can just use a reed switch, which is a small magnet-activated electronic switch. It's already been done by myself and others, and there are even threads about it.Probably be a good idea to open the right Joycon and add a little switch in there (a switch on your Switch, ha).
Or a magnetic contraption sort of thing that when you place a magnet near it, it lifts a piece of metal and closes the circuit.
Probably be a good idea to open the right Joycon and add a little switch in there (a switch on your Switch, ha).
Or a magnetic contraption sort of thing that when you place a magnet near it, it lifts a piece of metal and closes the circuit.
Magnetic contraption? unneded, there are magnetic switchs, they are called "reed switch"
You can just use a reed switch, which is a small magnet-activated electronic switch. It's already been done by myself and others, and there are even threads about it.
I printed the one TX came up with, where you have to extract micro usb pins to use.. works like a charm and i dont foresee any major damage given the material used.
I printed the one TX came up with, where you have to extract micro usb pins to use.. works like a charm and i dont foresee any major damage given the material used.