seemingly works, took a old sata power cable, striped of the end of a shortened cable. lenght is so long that it fits in the rail without falling. windows detected the switch as a apx device , screen is black. hope fully this works.
Why don't people's just solder the two pins together, its easy you cant go wrong I did it last night worked a treat! 
Edit: also its easy to remove the solder again, if needed just pin join your iron onto your solder again and let it lift back up on the tip or you can use a solder sucker pen..
Edit: also its easy to remove the solder again, if needed just pin join your iron onto your solder again and let it lift back up on the tip or you can use a solder sucker pen..
Last edited by Reecey,
not all people can solder/are confident enough to solder those joins and or have a solder station/equipment.Why don't people's just solder the two pins together, its easy you cant go wrong I did it last night worked a treat!
After waiting 4 weeks my ESP8266 came in the post yesterday for my PS4 (so much to do / read yesterday!)
It came with the pcb header pins which I won't be using gonna see when I can come up with later
Sent from my SM-G935F using Tapatalk
It came with the pcb header pins which I won't be using gonna see when I can come up with later
Sent from my SM-G935F using Tapatalk
D
Deleted-355425
Guest
After waiting 4 weeks my ESP8266 came in the post yesterday for my PS4 (so much to do / read yesterday!)
It came with the pcb header pins which I won't be using gonna see when I can come up with later
Sent from my SM-G935F using Tapatalk
They make one of these with a battery now
The end jammed down the rail is slightly bent up so it presses against the pins. The sloppy end seen sticking out is there so its easier to remove.
It works reliably, I've gotten RCM 5 out of 6 times now.
Thanks to my friend for holding the thing while I took a picture.
Best solution iv seen so far, thank you kindly.It connects to pin ten to either pin 1 or 2. Both are ground and short the pin if connected
- No one is chatting at the moment.
-
-
-
-
-
-
-
-
@
SylverReZ:
If you want a good system to port it to, at least have a good programmer and knowledge.+1 -
-
-
-
@
Psionic Roshambo:
I didn't know they made an MSU cart for the Genesis.... I knew about the SNES one and the library for that is rather large but the Genesis one has very few games+1 -
-
@
SylverReZ:
An FPGA could probably replicate the chip's functionality without buying donor parts.+1
-
-
-
@
Psionic Roshambo:
Like not emulating the entire SNES but just a loader and the enhancement chips perhaps even slightly overclocked like FX-2
-
-
-
-
-
-
-
@
SylverReZ:
@Psionic Roshambo, The Doom NES cartridges, a few batches were made. One was given to AVGN as seen in his Doom video.+1
-