View attachment 362358View attachment 362359View attachment 362360I think firmware 2.5 is not compatible with my nand(KLMCG4JETD).The hekate always say "emmc is in slower mode"(eMMC info).And once you laod stock HOS,end with failure and the boot0 is broken .Luckily I had backuped my nand.
When I change back the tx-chip,everything works well.
Post automatically merged:
View attachment 362361
The left is original boot0, right is changed boot0.The right one is backuped after boot failure.
I don't suggest people start with the switch as their first "solder" job.. but, if they got the money for replacements, or time for spare parts.. than go for it..
Doing an rgh3 on an Xbox 360 is a cheap starter solder project. If you can connect to the c5r35 via, this switch mod looks very doable.I don't suggest people start with the switch as their first "solder" job.. but, if they got the money for replacements, or time for spare parts.. than go for it..
I don't suggest people start with the switch as their first "solder" job.. but, if they got the money for replacements, or time for spare parts.. than go for it..
hahahhahahahaha
Hwfly why are u so slow :-P
most take longer picofly fasterIt just mean your is poorly trained, mine boot like instantly.
View attachment 362432
View attachment 362433
View attachment 362434
most take longer picofly faster
even has video new switch lite instant boot
Echoing lack of success with an "RP2040-ONE", single red blink.
My best guess is the flash ID differs from expectations, given the one notable difference is a different flash capacity.
Presumably 2.6 would thusly make it work, but no ETA means probably worth returning and trying the Zero.
currently it better almost a week of use without problems homebrew games etcIf it wasn't train properly then obviously why it boot slower, beside picofly doesn't have 100% glitch rate.
currently it better almost a week of use without problems homebrew games etc
very rare to failNot really since mine glitch like 100% of the time, and boot within 2 seconds. I seen in the thread people said picofly doesn't always glitch.
very rare to fail
I managed to make an alternative of entering OFW by restarting through hekate so it works 100%
I have no simple way to confirm the start of the flash ID; I tried compiling the example, both as is and modified for USB output, and got nowhere.rp2040-B2 with Flash ID starting as E6-6x ??
I agree with youI mean picofly is still not perfect, compare to one that glitch all the time and boot time the same as the picofly, it come down to the timing on the glitching part.
did you cut the signal tracks under the Dat0 adapter?Picofly OLED no flex cable
boot0 is the same for switches with same firmware version, so you can get kown your firmware version form fuse,and restore a same version boot0 .I am in the same situation as you. Is it because of the Chinese system
Did you use unlock. bin
"Currently, I only have a backup of the incorrect boot0. How can I restore the correct boot0?"