so I'm going to have to leave the project stopped until a new update
I'm going to continue my c++ project
I'm going to continue my c++ project
Atmosphere and Hekate, everything is in the pack, just to run the pack and choose the SD as destination.
Ha yes if you are in 16.01, I should make you a pack: I will see if I have time to do it this weekend!
I know it's all there but I need to know exactly which pins on the mosfet to solder to.
Because when I soldered earlier it started burning the cable on the cpu
Because when I soldered earlier it started burning the cable on the cpu
The 2040 with the Alibaba W logo appears in the legitimate system card logo. After moving the cable, it works normally, and multiple devices appear. I suspect that the quality of the W mark 2040 is not good.
look at the picture there u see the pins u need to solder it tooI know it's all there but I need to know exactly which pins on the mosfet to solder to.
Because when I soldered earlier it started burning the cable on the cpu
did u isolate the pin under the mosfet?
what do u dont know?
if u isolatet the pin that sits under the mosfet?
make sure the dot on the mosfet is on the buttom left when u solder it on
if u solder it on like in the picture u have to isolate the pad that sits under the mosfet with uv mask
u removed the right cap yes?
so u have 2 solder pads
the bottum one u isolate (cover it with uv mask and harden it with a uv lamp)
then u solder the top right pin from the mosfet to the top solder pad where u removed the cap from
then u solder the middle pin from the mosfet to the right side from the left cap
show us some picture of ur work
okay pin out is right now u can solder it to the apu after u did that show another picture
the wires to the cap7pad should not be to long
u can also use the video @rehius just uploaded for a guidance or solder it on the way the guy in the video did it
Similar threads
- No one is chatting at the moment.
-
@
Psionic Roshambo:
I wonder if I could recommend that to some emulation devs that perhaps the sound could use some smoothing out to simulate those old TVs -
@
Psionic Roshambo:
I think a few of the early systems could benefit from that, at least up to the 8 bit generation, by the 16 bit generation I think TVs had gotten a lot better in almost every way
-
-
-
-
-
-
-
-
-
-
@
Xdqwerty:
it says it only works for the original R4, R4i Gold (r4ids.cn), R4iDSN (r4idsn.com) and Acekard R.P.G. -
-
-
-
-
-
@
Psionic Roshambo:
Just give it a try, but honestly if you have a 3DS you can play DS games without a card just off the internal SD card
-
-
-
-
-
-
-
