you used 3 47ohm resistors?colleagues after installing the picofly I am getting this message
nope I installed the resistorsyou used 3 47ohm resistors?
That message is normal without the resistors.nope I installed the resistors
There is your answer, as stated several times in the past, you need the 3 * 47 ohms resistors to allow the EMMC works fine after install the chip.nope I installed the resistors
remember, english only, is on the forum rules https://gbatemp.net/help/terms/Ya logré que pasará y no me arroja el problema de la emmc ya se le colocaron las resistencias y ahora me da este error
It works for other people so I'm guessing it's your firmware on the chip or installation
Have you surely unlocked the FW ?I have already managed what will happen and it does not give me the problem of the emmc, the resistors have already been placed and now it gives me this error
ASking for anyone to answer, but question, what exactly are the resistors doing to allow for fullspeed? Is it like a boot mechanic that they see the voltage is out of spec so the switch limits the emmc speeds?There is your answer, as stated several times in the past, you need the 3 * 47 ohms resistors to allow the EMMC works fine after install the chip.
filtering interferenceASking for anyone to answer, but question, what exactly are the resistors doing to allow for fullspeed? Is it like a boot mechanic that they see the voltage is out of spec so the switch limits the emmc speeds?
They avoid "noise" and allows for the console and chip share EMMC lines, whitout the resistors the chip overtake the EMMC and console can't read it.ASking for anyone to answer, but question, what exactly are the resistors doing to allow for fullspeed? Is it like a boot mechanic that they see the voltage is out of spec so the switch limits the emmc speeds?
Did you flash unlock.bin?Hello, i've try the installation on OLED, it went fine (it's able to start Hekate) but i can't create the EMUMMC, it says: BIS keys validation failed! .. any tips ?
if i boot OFW works perfectly
yes, i upload the file on SDCARD, launch the payload, click on flash, come out flash successfully, but no change, same issueDid you flash unlock.bin?
The developer said that was bugged, might be best to try and flash the unlock manually through usbyes, i upload the file on SDCARD, launch the payload, click on flash, come out flash successfully, but no change, same issue
Q - Is AWG40 thick enough?
A - Yes. AWG40 is good for around 90mA.