Just need some switches like these:Someone need to build a special shield that can make you keep the buttons
https://www.mouser.com/ProductDetai...oswitch/2425753-2?qs=amGC7iS6iy/a1V1RQp1Sww==
Fantastic response. I actually have. The resistor being mentioned is 20K Ohm as in 20000, and it's normally not needed. Just like rehius said above. Please stop spreading misinformation.
hello, I was finally able to boot the chip, check the soldering and that's it, but now I wanted to test OFW, check that the connection between the points and the pico fly have 47ohm resistance. I don't know what else I could check pkg1 decryption failed bek is missing
Attachments
I think it's a little better to leave two pads and connect them with tweezers
- Joined
- Jan 5, 2009
- Messages
- 834
- Trophies
- 1
- Age
- 43
- Location
- Perth,Australia
- Website
- Visit site
- XP
- 1,244
- Country
everything just looks burnt :/
Very bad install but I'll clean up if i can get it working
Hi guys, I have a question. is it possible to replace the IRFHS8342TRPBF mosfet with something else? I can't find it in my area. also, does anyone have a schematic for the nintendo switch lite?
please help me to find, 170 pages of post!! haha
Page 166.
thats flux that is cleaned up now and will be cleaned again when i resolder things
Been looking about but this thread is kinda all over the place. 30awg wire seems to be the most used? Of 34awg? Some people I've seen say 34 isn't enough for power?
So should I just get some 30awg and do everything with it?
So should I just get some 30awg and do everything with it?
I'd like to thank everyone for leading me into a false sense of hope posting blown up pics of components and me think "AHH they don't look to small, I might be alright soldering this myself"
Everything's bloody tiny!
Hopefully the resistors are the correct ones
Everything's bloody tiny!
Hopefully the resistors are the correct ones
Attachments
Similar threads
(
