Just need some switches like these:Someone need to build a special shield that can make you keep the buttons
I think you haven't seen this full topic since page 1
hello, I was finally able to boot the chip, check the soldering and that's it, but now I wanted to test OFW, check that the connection between the points and the pico fly have 47ohm resistance. I don't know what else I could check pkg1 decryption failed bek is missingI'm pretty sure that is Red signal on the inversed LED (green after USB write), you should solder the RGB mode jumper.
the firmware from the top of this page might help you. (oh, from the previous page now)
Did you flash the unlock firmware?hello, I was finally able to boot the chip, check the soldering and that's it, but now I wanted to test OFW, check that the connection between the points and the pico fly have 47ohm resistance. I don't know what else I could check pkg1 decryption failed bek is missing
I think it's a little better to leave two pads and connect them with tweezersJust need some switches like these:
https://www.mouser.com/ProductDetail/TE-Connectivity-Alcoswitch/2425753-2?qs=amGC7iS6iy/a1V1RQp1Sww==
Yes, i flash 2.5 fix Toshiba and unlockDid you flash the unlock firmware?
everything just looks burnt :/
Very bad install but I'll clean up if i can get it working
View attachment switchlite2.jpg大家好,我有一个问题。是否可以用其他东西替换 IRFHS8342TRPBF MOSFET?我在我所在的地区找不到它。另外,有没有人有Nintendo Switch Lite的原理图?
yes booth answers are on past post.Hi guys, I have a question. is it possible to replace the IRFHS8342TRPBF mosfet with something else? I can't find it in my area. also, does anyone have a schematic for the nintendo switch lite?
yes but not see the pin in this image
please help me to find, 170 pages of post!! hahayes booth answers are on past post.
please help me to find, 170 pages of post!! haha
thats flux that is cleaned up now and will be cleaned again when i resolder thingseverything just looks burnt :/
Yes it will absolutely work, but he asked for buttons.I think it's a little better to leave two pads and connect them with tweezersView attachment 361745