Installed into a lite today to the best of my current ability. So far it just blinks red once like after programming but nothing after and nothing on screen.
- Joined
- Jan 22, 2014
- Messages
- 248
- Trophies
- 1
- Age
- 40
- Location
- Cape Town, Western Cape
- XP
- 1,810
- Country
My flex cable have pin 3 and 4 shorted and works well
To use this on a Mariko all I need is a rp2040zero, a hwfly v2 cable and a couple of 47ohm smd resistors correct?
I removed mosfet entirely to see if it would at least blink cyan or do something, nope same behavior
This is wrong,
Gate goes to Pico
It's been clarified many times before that this picture was wrong.
Cap is source and Drain
@linuxares is it possible to edit the original post of this image saying it is wrong? I remember seeing it maybe a dozen pages ago but can't find it. Maybe it could help for the people to not repeat the same mistake again and again...
Is the removed cap just bridged?
Also I removed CMD point and it boots ofw, but with cmd connected it does nothing
I have tried using the PGA2040 from Pimoroni for this but no success. It simply blinks red once and that is all nothing afterwards. I have connected all of the GPIO pins as required and even installed an addressable LED on GPIO16, because the Waveshare 2040has the LED connected there. Are there any other relevant hardware differences? I couldn't find much that has relevance. Has anyone successfully tried other Picos?
Ok, thought you might say that
Using 'Chipquik' flux and an 'Atten ST-80' ultrafine soldering tip.
I just ordered a hot-air rework station, HD microscope & screen :/ a bit far fetched, but need a XAJ & XKJ done by Tuesday!
I have uploaded a video, but as a new user here it won't let me post it.
If you type in Youtube: "Picofly Erista - MOSFET Bad CPU Pin" it will come up with my first switch-on video.
Type in: "Ultrafine Atten ST-80 Soldering Tip" and you'll find the tip I'm using.
I am meeting 'A Friend' tomorrow who has a load of V1/V2 flexes left over, so fingers crossed it's defo my soldering!
I did do some original SX installs with these in the past and had no issues.
I would just like to say - "You guys are f!!king legends" <3
Amazing & keep up the good work, do you have a donation link?
Thank you for your time,
Ant
Last edited by RiotRetroGaming,
Similar threads
