what if their is new update to flash , just in case i remove the usb port already? how can i flash it again ?
you can use the mod on the last page where that temper replaced the USB port by a ribbon connector, then solder the conector to a ribbon cable. or you can just put a temporary connector soldering the only 4 cables needed, +5v, GND, D+ & D-
Ok that makes sense, however in this post https://gbatemp.net/threads/picofly-a-hwfly-switch-modchip.622701/page-135#post-10107313
the user @billybobxxx does not even touch second capacitor, he soldered only to the first one.
So which approach is better?
it easy, using search function:ohmygod. my brain will explode. can you provide me a link .thank you so much !
https://gbatemp.net/threads/picofly-a-hwfly-switch-modchip.622701/post-10106460
and
https://gbatemp.net/threads/picofly-a-hwfly-switch-modchip.622701/post-10106523
I think he used a ps controller connector.
Post automatically merged:
by the way you can buy the ps controller connection and ribbon just like this one:
better test it before u remove it, if not u still need to solder it back
I didn't understand, but you need 1 mosfet connected preferably to 2 capacitors.
was talking about this where cap was removed and guy was having problems glitching with a single mosfet
its better to read the important post at top, there are several examples of correct installation.
Post automatically merged:
Seems the changes are small:
Last edited by impeeza,
So... I've been following this for a while now, seeing how you all are excited and stuff made me order an Rp2040 zero, V2 hwfly cable set and a set of 470K SMD resistors and a soldiering kit... I have a V2 Mariko Nintendo switch... Hope that will be everything i need to get going
You got all that right but the resistors - They are 47Ohm not 470 and not 470k
Oh really? So these will not work?
Attachments
If 47 Ohms not on there then nope. Make sure not 470 and def not 470k. I did a v1 patched erista without resistors and hekate stated emmc in slow mode yet all loaded fine ofw, cfw and emu cfw. I ordered the right resistors and waiting to see if slow mode goes away with 47 Ohms.
www.digikey.com/en/products/detail/vishay-dale/CRCW060347R0FKEAC/7924025 0603
www.digikey.com/en/products/detail/vishay-dale/CRCW080547R0FKEAC/7922299 0805
I ordered 2 diff sizes to see what I like better
We need one guide with all this info and what pin to solder on cpu flex for all versions so the same questions don't keep getting asked and so it helps everyone out. I know there is an AIO thread just started but its still needs more info.
- Joined
- Sep 2, 2020
- Messages
- 1,269
- Trophies
- 0
- Age
- 39
- Location
- TORONTO
- Website
- form.jotform.com
- XP
- 2,199
- Country
They acutally secretly uploaded OLED scan but very slow loading time for each layer.
https://balika011.hu/switch/oled/
Similar threads
