I subscribe to this as well, good point. Maybe just 1 ground point to attach to the metallic shell would be sufficient. This would ensure a robust positioning, and as well another GND point for the glitching.
Picofly AIO Thread
- Thread starter Adran_Marit
- Start date
- Views 514,376
- Replies 3,351
- Likes 60
I already thought about this but still looking for another way to proper mount cable into CPU surface than solder it into metal frame. But if there is no better solution, I will be back with SX cable way.
Yeah, I agreed with i) and I would like to move in to new position (below image)This is awesome work!
If I may, a couple of suggestions:
i) move the P15 (gate) test point to a different position, so it stays away from the metallic shell surrounding the CPU (less probability of shorts)
ii) change the "k" to "c" as requested on the other thread by rehius.
PS: loved the homebrew slogan
For ii), after I read rihius comment, I have changed it and edit this post.
Thank all of you for your feedbacks/advices.
Colleagues, I have a question. The only drawback by not placing the mosfet is that I won't be able to enter the nand, everything will have to be done from the emunand?
Might as well solder gate pin of mosfet directly to pin 15 of rp2040 and run 2 wires to cpu. Much cleaner tbh.
Not to mention it won't hinder with heatsink height clearance.
Incorrect. The Mosfet is *REQUIRED*
you are thinking of the resistors, if you don't have them, then only the emunand will work
- 47-50 ohm resistors - SMD 08085 or smaller <---
https://kiloohm.info/smd3-resistor/471
thank you then you are fine
rookie question is the mosfet yes or is it mandatory?
mosfets are a mandatory, it's most crucial piece after the chip itself. The resistors are there to be able to boot HOS.
Wednesday I live in a third world country hahaha and of the ones mentioned here I can't find it, will it be some other different reference that you can inform us of?
Yes, I ordered them and they take about 3 months to arrive
another question after installing everything to enter atm it's time to launch a payload to start it with the pick you have to unlock something
Depends.
https://github.com/Ansem-SoD/Picofly/tree/main/Firmwares
I would just get the PiCoFly FW2.5+unlock.uf2, then you don't need to do the manual unlock.
1-So the only file that I have to pass to the rp2040 is this and that's it PiCoFly FW2.5+unlock.uf2 is already soldering and assembling and that's it, with this cro emunand and can I enter both emunand and sysnan?
2-
And last question in case you have to update the sysnan you can without problem or there is some problem or is there something that one has to do separately
Similar threads
