Yeah that's an eristaWaaaait a minute. I always thought I had a Mariko Switch but...
If this one below is my box, does that simply mean that I have a patched Erista? I'm mindblown at how I could be oblivious to that
View attachment 360349
Yeah that's an eristaWaaaait a minute. I always thought I had a Mariko Switch but...
If this one below is my box, does that simply mean that I have a patched Erista? I'm mindblown at how I could be oblivious to that
View attachment 360349
so someone posted a youtube video using piko ?
some one cut all the metal back-plate and the back case of the switch, obviously will no work for long time, but...No
If it's still not done I'll do it after work
you have to, they are required for SysNAND to properly work.I don't understand this on the faq
Q: Need resistors?
A: SysNAND will not work. Line interference. Only emuMMC.
So we have to put resistor or not ?
This is what im wondering myself. Some said 47 and other said 470.What's with this 470 ohm resistor? Some using no resistors, some sayin 400 and some 450 . And this wool. net just posted saying it requires 47 ohm..
It needed to use Synand and it’s 47 ohm resistorThis is what im wondering myself. Some said 47 and other said 470.
the number 470 on the resistor means 47 ohms, the two first digits are the value the last digit is the number of zeros on the multiplier (when the number have 3 digits)What's with this 470 ohm resistor? Some using no resistors, some sayin 400 and some 450 . And this wool. net just posted saying it requires 47 ohm..
Cheaper than the hwfly that’s all I knowSo what is the shopping list for this?
0805 1% or 5%? is it 470R or 470K?u can use 1206 they are fine other users also posted a pic with them using them , but 0805 should be better since they are a little smaller
Post automatically merged:
i orderd 0805 for me
47 no K - Yeah those should be good and 0603. Anything bigger will work but will make it harder to fit / install.0805 1% or 5%? is it 470R or 470K?
0805 1% or 5%? is it 470R or 470K?
It doesn't need to be terribly specific, it just helps lower the interference on the eMMC lines so it can be read (seems to only be an issue once it switches to high speed communication) any 47 ish ohm resistor should work just fine. Mine were 0603 5%0805 1% or 5%? is it 470R or 470K?
if you're garbage at soldering don't even try it. It can't be updated without disassembling the Switch yet anyway, and needs USB and buttons removed to fit.I was going to buy 5 hwfly today, but I just heard this news. Would it be better to wait without buying it now? And when I looked it up more, I heard that the back plate cannot be closed if the pico is installed.
Which direction would be good? Guys, give me some direction.
Thank you so muchif you're garbage at soldering don't even try it. It can't be updated without disassembling the Switch yet anyway, and needs USB and buttons removed to fit.
AliexpressEveryone did a fantastic job! You are part of the switch modding history now!
Now I need to figure out where to get that ribbon cable
All models:So what is the shopping list for this?