Update i cannot cancel the order
no worries. End results is all that matters. I’m not ripping out my HWFLY chips, that’s for sure.
no worries. End results is all that matters. I’m not ripping out my HWFLY chips, that’s for sure.
I guess we'll have to wait for rcpd's release, to finally see something open sourced. While I wait for that, I understand that the solder work will be the same.
So, is this the hwfly flex cable that I should buy to avoid using a mosfet and more complex wiring? (Mine is an ordinary Mariko Switch)
So, is this the hwfly flex cable that I should buy to avoid using a mosfet and more complex wiring? (Mine is an ordinary Mariko Switch)
I found this to be true with the OLED and HWFLY. If the switch was powered off for a while and was in a cold room it would boot much slower the first few times. Same thing happens when my battery dies. After a few boots and a good charge I boot into hekate instantly.
PSA: if you like the hwfly / instinct chips, pop over to the Ali store and let the sellers know that there’s a new game in town. Might make them lower the current prices faster, no?
Yes, this one is perfect for the job. By the time you solder the edge connector and 4 SP points you’re like 99% of the way there. Just sayin.
Post automatically merged:
Might.
(laughs hysterically in Pico)
You have so much knowledge. I know you have concerns about posting full source. Have you considered posting part of it in a generic form? Maybe something like "Glitching a Tegra X1 with a raspberry pi".
The firmware developer @rehius has not supported it, apparently because of its physical size, the RP2040 has a pin29 that is used for DAT0 if I'm not mistaken it doesn't have the Rasperry Pi Pico, too bad because I have one of those and it's hard for me to get an RP2040. Anyway, now I am going to write to him to see if by cutting the last 5 pins he will get excited to write a variant for that board.
Congratulations rehius and thank you!
The best thing about this is that the mod chip sellers are screwed now.
No more huge markups.
Great job everyone!
The best thing about this is that the mod chip sellers are screwed now.
No more huge markups.
Great job everyone!
it's just a matter of time until new modchips and ribbon cables based on rp2040 pop up at chinese marketplaces like aliexpress and others.
huge markups again.
huge markups again.
so what?
they will always try to make a huge markup.
but atleast now u know u can do it cheaper right?
aslong the prices for the rp2040 dont go up it doesnt matter to us :-)
Similar threads
-
@
RedColoredStars:
i dont know why tv manufactures put the hdmi ports in dumb locations so the cables have to stick out, and then down, putting strain on the ports. Instead of having the ports along the bottom edge of the tv facing downwards. -
-
@
SylverReZ:
@RedColoredStars, I hate that too where you have to use an HDMI extension for an Amazon Fire Stick.+1 -
-
-
-
-
-
@
SylverReZ:
Had a ton of bugs and often crashed. It even didn't support DOS compatibility with older games. :feelsbadman:
-
-
@
RedColoredStars:
I downloaded XP on dialup when it came out. Overnights for like a week. cuz I couldn't tie up the phone line during the day. It was so awesome and worked so great going from ME to XP.
-
-
-
-
-
-
-
-
-
-
-
-
-
-
