Oh, if you got it?
then n/m! Didn’t catch that you were saying you were all set!
then n/m! Didn’t catch that you were saying you were all set!
Don't rlly know if iam all set it looks like it :X still a switch noob here.
I follow this https://rentry.org/EmuNANDNewSDcard#nxnandmanager nx method but after booting it just orders me to redownload my games so i look at the emummc.ini and change it a little, swap that emutendo folder for just nintendo and bring back old folder names for things inside Emummc. I don't touch that sector id becouse if it works i think is good xD Is it good?
Still idk why my older card behaves like sh** in switch i run some tests on it and looks like the card is perfectly fine
There’s no way you’d have your games and saves and such if your emunand wasn’t working.
Check your Firmware version and make sure it looks like this:
15.0.1 | AMS 1.4.0E
The E on the end tells you that your on Emunand. If you have an S instead that means you are on Sysnand.
Still idk why my older card behaves like sh** in switch i run some tests on it and looks like the card is perfectly fine
Maybe do a deep format on your old card with something like rufus?
Pretty dumb question but It's because I'm not used to this kind of stuff this much but every time I have to use JKSV on my sysnand I always go offline, then boot atmosphere and do what I have to do, but this time I forgot to go disconnect on Wi-Fi and I booted Atmo on sysnand, what are the odds that I'm screwed?
Last edited by Mayo1990,
Hello, I've been having a very weird problem which I could replicate with a different SD card with the same setup.
Clean atmosphere install fusee updated and hekate will boot to a black screen after nintendo and will boot to ams normally if you reboot. The weird part begins when if you reboot again, it's a black screen, then normal, black screen, normal, black screen, normal.
Every other boot I get a black screen and wasted several hours to:
Switch was jailbroken with the rentry guide
Hekate.ipl below:
Clean atmosphere install fusee updated and hekate will boot to a black screen after nintendo and will boot to ams normally if you reboot. The weird part begins when if you reboot again, it's a black screen, then normal, black screen, normal, black screen, normal.
Every other boot I get a black screen and wasted several hours to:
- redo emunand
- try clean atmos
- try atmos with sysmodules
- no sigpatches
- with sigpatches
- Entirely different SD card with clean atmos install
Switch was jailbroken with the rentry guide
Hekate.ipl below:
Code:
[config]
autoboot=0
autoboot_list=0
bootwait=3
backlight=100
autohosoff=0
autonogc=1
updater2p=0
bootprotect=0
[Atmosphere CFW]
payload=bootloader/payloads/fusee.bin
icon=bootloader/res/icon_payload.bmp
[Stock SysNAND]
fss0=atmosphere/package3
stock=1
emummc_force_disable=1
icon=bootloader/res/icon_switch.bmpDo you have naughty stuff running when you went Online? NSPs, XCIs, cheats? If so you might be at risk. Typically just having AMS is not a ban. JKSV isn’t a huge risk either. Each thing adds up though and increases your profile. We only have anecdotal info…not a rule book. The only thing you can do now is go and sin no more and be more careful next time.
Nope, I only have "vanilla" Atmosphere and I just exported my Violet save, edited it, re-imported and saved again in-game. Didn't go online in game nor anything, but I just realized I didn't disconnect my Switch while doing so, which is something I usually so.
The Switch reports in immediately and dumps it’s logs. You’re probably OK though as long as there’s no piracy or cheating but the things you did absolutely can expose you to a ban so be more careful. That’s all.
Nah, no cheating nor installing XCI/NSPs has been involved. Just plain save editing.
ye its E on the end and ams 1.4 in the middle, tendo sites are blocked, games are booting i have my saves.
i will try that but now iam just w8 for new samsung card
I have a similar problem yesterday in my case i was able to boot once, sometimes twice to atmo normally but later after tendo logo i get a black screen
Solution for that was a new sd card
But if you can replicate the same exact scenario with the same amount of attempts i doubt it is sd card ofc with one exception perhaps if your second sd card is as bad as the first one you will get similar results.
how long it takes you to complete boot after tendo logo disappears on these cards? On my "bad one, it takes some time on my new one it is like 2 sec.
Sigpatches can be found here:
Sigpatches (GBATemp)
E: IPS patches can do a lot of different things so I would say that Sigpatches are IPS patches but not all IPS patches are Sigpatches. Kinda like that rectangle/square thing.
I hold power button until full shutdown, the reboot then just works as normal. I forgot to mention the other SD card could boot back to back for a bit. I've had this sd card for 6 months now, do they break this easily?ye its E on the end and ams 1.4 in the middle, tendo sites are blocked, games are booting i have my saves.
i will try that but now iam just w8 for new samsung card
I have a similar problem yesterday in my case i was able to boot once, sometimes twice to atmo normally but later after tendo logo i get a black screen
Solution for that was a new sd card
But if you can replicate the same exact scenario with the same amount of attempts i doubt it is sd card ofc with one exception perhaps if your second sd card is as bad as the first one you will get similar results.
how long it takes you to complete boot after tendo logo disappears on these cards? On my "bad one, it takes some time on my new one it is like 2 sec.
Best way to fix sector id is to tell Hekate to fix emunand. It will find it on your SDCard and fix it for you!
Post automatically merged:
This is spot on. :-)
You can also hit (X) on your user icon and it will give you the option to create all save folders for all games. Helpful if you have a bunch to recover.
Oh, can also use Google Drive to share between switches. I just got mine configured this way…it’s the bee’s knees, honestly.
E: https://gbatemp.net/threads/moving-saves-between-2-consoles.622608/post-10013898
It worked for MotoGP22 but not for Zelda. I started Zelda from the beginning, did alaready multiple saves, but it cannot find the old save from the old SD card! And now, it already have the AUTOsave and also the saves I did from the fresh start, but not the old save!
Do we need to have specific names for folders or files or something like that?
Because in the case of MotoGP, the folder is the titleID but in the case of Zelda, it is the name of the game itself!
Last edited by HelloShitty,
I’ll install it and see if I can find anything weird. BOTW, correct? Which UPD are you on?
Folder names should be just as they are saved by JKSV…no need to move things around manually.
Hold the power button until full shutdown? But you boot to the system mmc not emmc after? IF yes that's normally because it is not booting from sd card but if you are pumping some payloade it is normal too because mine always runs after the first injection.
So there is a difference between these cards but both eventually fail to boot? How long does it take on them to boot after the Nintendo logo disappears?
I don't know my old one is years old but i killed a few in just months before not in the switch but yea they can sometimes just break.
Last edited by Lamcza,
Sorry, what is BTOW? I feel it's something obvious, but I'm not getting there!
What I'm going to do is to create the backup again in my old SD card an try again.
One is a Kioxia 128 GB the other is a Samsung Evo 128 GB, both start failing to boot after a while. When it boots properly both just boot as normal. When it doesn't boot and gets stuck on a black screen I have to force shutdown to boot properly. Right now though I just booted normally back to back right as I was reading your response with 0 changes to the CFW. I think this might be just an SD card going bad I guess? If the reader was broken it'd just straight up not read I'm guessing.I don't know my old one is years old but i killed few in just months before
So there is a difference between these cards but both eventually fail to boot? How long does it take on them to boot after the Nintendo logo disappears?
Oh no i just order 512gb samsung
I mean it can be a faulty sd card reader too ofc or something completely different but your symptoms are very similar to mine
Just boot it 10 times on the new sd so far 0 problems and iam using the same copy of atmo and hekate from my old sd
Last edited by Lamcza,
- No one is chatting at the moment.
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
@
RedColoredStars:
There is an actual trailer with footage too. lol. Going to watch it tonight. Grabbed it from... a place. -
-
@
SylverReZ:
@Psionic Roshambo, JonTron's back yet again until he disappears into the void for another 6 or so months.+1 -
-
