Hey idk maybe someone here had a similar problem - or can give me a solution i didn't try yet.
today i changed my switch's fan because the old one was just loud and shattering anymore.
everything worked perfectly so far - i can start it and normally boot it and also the SD Card reader works fine - i tested it by looking at the setting if it can tell me how much space is available and also took a look at screenshots i took
So I next plugged in the USBC cable into my usual "bootslot" - then into the switch, turned it off - clipped in my RCM Jig - opened the program and.....
nothing. i made sure the drivers are installed, i switched the port i switched the cable - nothing.
After hours of switching the fan i'm really frustrated right now ... i hope someone can give me any tips
thank yall
today i changed my switch's fan because the old one was just loud and shattering anymore.
everything worked perfectly so far - i can start it and normally boot it and also the SD Card reader works fine - i tested it by looking at the setting if it can tell me how much space is available and also took a look at screenshots i took
So I next plugged in the USBC cable into my usual "bootslot" - then into the switch, turned it off - clipped in my RCM Jig - opened the program and.....
nothing. i made sure the drivers are installed, i switched the port i switched the cable - nothing.
After hours of switching the fan i'm really frustrated right now ... i hope someone can give me any tips
thank yall