I recently purchased an unpatched switch. Everything was going (semi) smoothly as far as injecting payloads, launching CFW, etc. Until one time I was loading up and powered it off as it was booting into the CFW. I attempted to power it back on and had no luck whatsoever. I determined that it wasn’t turned off but that it was stuck in autoRCM which I had enabled. All of the guides I followed suggested that I plug it into my PC and inject the payload. I did this one time successfully. However, I accidentally injected the payload without my SD card inserted (rookie mistake).
I received the message that there was nothing to send the payload to and got the option to power it off and try again. I selected the option to power it off and then I plugged it into the computer with the SD card inserted this time but it wasn’t detected with tegraGUI. I followed many guides but it seemed that no one had that had the same problem. Can anyone help?
I received the message that there was nothing to send the payload to and got the option to power it off and try again. I selected the option to power it off and then I plugged it into the computer with the SD card inserted this time but it wasn’t detected with tegraGUI. I followed many guides but it seemed that no one had that had the same problem. Can anyone help?