I just received a Switch in the mail to repair, everything is working except for the SD Card Reader. I swapped with a known working SD card reader, and same thing. The pins are actually pretty darn immaculate. I don't see anything obvious. Are there any CAPS or fuses to check? Anything else I can be checking? Trying to run Hekate, and it refuses to detect the reader. Picture attached.
Hardware SD Card Reader Not Detected - PINS are FINE
- Thread starter justaplaneguy0
- Start date
- Views 1,389
- Replies 3
Check this thread - https://gbatemp.net/threads/nintendo-switch-sd-card-alternative-points.579623/
Check with a MM if the point on the back are making a connection. Also check if power is being supplied to the VCC lines.
Also, just check the continuity from the molex pins to the respected test pads. Again, check that thread to know where they go.
Check with a MM if the point on the back are making a connection. Also check if power is being supplied to the VCC lines.
Also, just check the continuity from the molex pins to the respected test pads. Again, check that thread to know where they go.
FIXED!!! So stupid... a pin or 2 didn't have a good solder connection to the board.... Fluxed it, then used my chizel tip and made a few passes and both sides re-flowing all pins. Works like a champ now.
Similar threads
