So I have an old dead switch that was bought faulty a long time a go. It never had any shorts so have always thought it is a software issue?
I think it might be a firmware fuse miss match, have read you could try choidujoux on a pc but it doesn't work on the fuse count I am on.
I have tried a few basic things but not succeeded. have been able to back up the nand boot 0/1 though.
I got a copy of mattytrogs unbrick pack and thought would give this a go but straight off I try to get my Biskeys and get the below error.
Keyblob 0 - 5 corrupt. so straight off I am stuck, my knowledge on this is limited, can this be skipped? Is there any clever software out there that can rebuild from other files?
Any ideas to slowly progress me to the next step please.
Would love to get this switch going for my little girl while we are on lockdown!
I think it might be a firmware fuse miss match, have read you could try choidujoux on a pc but it doesn't work on the fuse count I am on.
I have tried a few basic things but not succeeded. have been able to back up the nand boot 0/1 though.
I got a copy of mattytrogs unbrick pack and thought would give this a go but straight off I try to get my Biskeys and get the below error.
Keyblob 0 - 5 corrupt. so straight off I am stuck, my knowledge on this is limited, can this be skipped? Is there any clever software out there that can rebuild from other files?
Any ideas to slowly progress me to the next step please.
Would love to get this switch going for my little girl while we are on lockdown!