Homebrew If I update my O3DS XL to 11 do I need to redo the homebrew process?

[Curtis Lister]

With Sun and Moon out I want to kess around with PKHeX and I have my O3DS homebrewed but I need to update to 11 to do so. It is 10.5 now I believe and if I do need to redo the process is there a way to do so. This far I installed broswerhax and just need to hold the L button when booting up.

Sent from my SM-N900W8 using Tapatalk

 

[TimX24968B]

With Sun and Moon out I want to kess around with PKHeX and I have my O3DS homebrewed but I need to update to 11 to do so. It is 10.5 now I believe and if I do need to redo the process is there a way to do so. This far I installed broswerhax and just need to hold the L button when booting up.

Sent from my SM-N900W8 using Tapatalk

do you have cfw? if not, install some BEFORE you update. You can go the emunand route or the A9LH route if you do not already have any. There are plenty of guides out there. A9LH is much more seamless, yet requires two downgrades, while emunand only requires one, yet is not as seamless (and takes up a bit more space on the sd card).
if you already have cfw:
A9LH: as long as luma is up to date you should be fine.
Emunand: for RxTools, i think you will be fine, but again, thats not 100% sure, so a switch of cfw MAY NOT BE NECESSARY. For luma, same as A9LH.

 

[dragonblood9999]

Yeah it at a low enough firmware to downgrade and install cfw easily. There are many tutorials on the site and lots of videos on YouTube on doing it

Sent from my SGH-I337M using Tapatalk