They cant even brake the emunand support on the n3dsxl so I doubt very much on a higher support firmware for those systems.
Set your menuhax to no-button launch. Then rename GW.3dsx to boot.3dsx and put it on the big sd card.
You need to backup everything on your sd card and reformat it with SDformatter.
I have these settings in my boot.cfg and so far I have 100% boot rate on my N3DS XL.
timeout = 0;
autobootfix = 8;
recovery = 9;
default = 0;
// Boot menu configuration
boot_config =
{
// Default timeout in secondes
// If timeout = -1, disable autoboot
timeout = 3;
// Some devices (n3ds?) seems to have
// some timing problems when using timeout=0 (autoboot).
// You may increase this value to improve boot success rate.
// Default delay (8) should be good for o3ds, 2 seems good for n3ds
autobootfix = 8;
// if timeout = 0 (autoboot),
// hold this key to enter the menu
// keycode list : https://goo.gl/4XLDIL
recovery = 2; // SELECT
// Default boot entry
default = 0;
// Boot menu entries (11 max)
entries =
(
{
title = "Cakes CFW";
path = "/Cakes.dat";
offset = "0x12000";
},
{
title = "rxTools CFW";
path = "/rxTools/sys/code.bin";
offset = "0x12000";
},
{
title = "Homebrew Launcher Grid";
path = "/boot_mg.3dsx";
},
{
title = "Homebrew Launcher";
path = "/boot_hb.3dsx";
},
{
title = "Quick Reboot";
path = "/3ds/3DS_Quick_Reboot/3DS_Quick_Reboot.3dsx";
},
{
title = "Quick ShutDown";
path = "/3ds/3DSQuickShutdown/3DSQuickShutdown.3dsx";
}
);
};
Boot rate with CtrBootManager was terrible for me last time I tried it with *hax 2.5, whereas with 2.1 it was stable. It seems to be stable now, though the Gateway launcher is still as unstable as ever. Last time I used CtrBootManager was on an o3DS though, and this is on my n3DS, so that might be why, but ihaveahax said it worked fine with *hax 2.5 on his 2DS, so I dunno.
