[Gambit_G]

I've got a DSTTi card which I attempted to update with TTi143UPGRADE.nds. Unfortunately it got stuck at 0.78% and unsurprisingly after 10 mins when I switched it off / back on again it's now not showing up as a DS card. I have a DSTT card that is working fine. Is there any way I can reflash the  DSTTi card using the DSTT card to load the source files and then flash to the DSTTi? I know this has been asked before but I can't see an answer to the "Can a DSTT card be used to start the reflash" question. Thanks.

Edited by Gambit_G, 27 December 2011 - 01:23 PM.

[akari212]

maybe you can recover it via Slot-2 NDS mode.

just a random guess, but i did tried it recovering my DSTTi clone from brick

[jimmyemunoz]

Go here to the sixth post. You can use the DSTT and the unbricker v1.01 Make sure you use the Homebrew Menu (another download) to boot up the unbricker.

Edited by jimmyemunoz, 27 December 2011 - 02:10 PM.

[Gambit_G]

Thanks for the info but I must be missing something. Running the unbricker on the DSTT on a DS lite (launched from the homebrew menu) and hot swap to the DSTTi card but then get "Your bricked firmware card HD=0, Your bricked firmware=0, This unbricker can't run on a DSi or 3DS or your card is bad. Shutdown". How can the EZ flash unbricker unbrick a  DSTTi card?

[Mbmax]

Gambit_G, on 27 December 2011 - 11:00 PM, said:

Thanks for the info but I must be missing something. Running the unbricker on the DSTT on a DS lite (launched from the homebrew menu) and hot swap to the DSTTi card but then get "Your bricked firmware card HD=0, Your bricked firmware=0, This unbricker can't run on a DSi or 3DS or your card is bad. Shutdown". How can the EZ flash unbricker unbrick a DSTTi card?

It can't, don't use it. This unbricker was made for the ez5i hardware only.

[Gambit_G]

Not going mad then :-) Any other thoughts on how I can unbrick a DSTTi with just a DSTT?

[bitonio6]

Gambit_G, on 27 December 2011 - 01:17 PM, said:

I've got a DSTTi card which I attempted to update with TTi143UPGRADE.nds. Unfortunately it got stuck at 0.78% and unsurprisingly after 10 mins when I switched it off / back on again it's now not showing up as a DS card. I have a DSTT card that is working fine. Is there any way I can reflash the DSTTi card using the DSTT card to load the source files and then flash to the DSTTi? I know this has been asked before but I can't see an answer to the "Can a DSTT card be used to start the reflash" question. Thanks.

It's because your DSTTi was not an 100% genuine! So now you need to buy another flashcard !

it exist no solution to save a DSTTi original (or not), bricked!

Edited by bitonio6, 29 December 2011 - 01:06 AM.