Hey all I have a Corona V2 (4GB) Im having problems glitching.
Hardware installed:
TX CR4 XL
TX CR QSB V4
TX 4GB NAND R/W SD Kit
Software using:
J Runner 7
Problem:
I'm 99% sure everything is soldered in correctly because I can read and dump my stock NAND no problem, however when I go to write an ECC file the console will no longer boot. I can see the Debug light on the Coolrunner flashing and the oscillator thingy whines at me like its trying to glitch. Ive waited an hour with as many settings as i could figure between resistor settings and the timing settings (8 must be on). It just wont boot into Xell. Any ideas? I can post pics
Hardware installed:
TX CR4 XL
TX CR QSB V4
TX 4GB NAND R/W SD Kit
Software using:
J Runner 7
Problem:
I'm 99% sure everything is soldered in correctly because I can read and dump my stock NAND no problem, however when I go to write an ECC file the console will no longer boot. I can see the Debug light on the Coolrunner flashing and the oscillator thingy whines at me like its trying to glitch. Ive waited an hour with as many settings as i could figure between resistor settings and the timing settings (8 must be on). It just wont boot into Xell. Any ideas? I can post pics