I have my my infectus set up using a 360-clip soldered to it.
After dumping the NAND's on my FAT a few times, until I was happy with it, I edited the dumps as per the dospiedras method and started to rewrite them to the NAND's.
The first NAND wrote fine, then the Infectus wouldn't connect to the second one. After trying again and again, I put it back to the chip I had already rewritten and no sucess with that one now.
After a closer look, it appeared the infectus firmware had corrupted as it was showing as 02Mod in the programmer, rather than Double NAND.
I have gone back to reinstall the firmware to infectus and I am getting the following.
When I try to load the .dat file I get:-
And it comes back with 'Failed to Verify FPGA'
If I try to erase I get:-
And it comes back with 'Failed to Program UROW'
I did find just before the firmware corrupt that the chip was getting hot, I have seen Deadlyfoez post regarding pins 13+14 on the ribbon cable, and tried this, but it seems to make little difference for reloading the firmware on the Infectus.
Any suggestions would be great.
TIA
After dumping the NAND's on my FAT a few times, until I was happy with it, I edited the dumps as per the dospiedras method and started to rewrite them to the NAND's.
The first NAND wrote fine, then the Infectus wouldn't connect to the second one. After trying again and again, I put it back to the chip I had already rewritten and no sucess with that one now.
After a closer look, it appeared the infectus firmware had corrupted as it was showing as 02Mod in the programmer, rather than Double NAND.
I have gone back to reinstall the firmware to infectus and I am getting the following.
When I try to load the .dat file I get:-
Code:
ActID = 02a121cf
ExpID = 02a121cf
Initializing Target Device...
Setting BSR Configurations...
Reading Security...
Verifying FPGA Array...
Verify 0 failed Row Number : 1242And it comes back with 'Failed to Verify FPGA'
If I try to erase I get:-
Code:
ActID = 02a121cf
ExpID = 02a121cf
Initializing Target Device...
Setting BSR Configurations...
Reading Security...
Erase...
ACTEL_SLOG_UROW =
FF FF FF FF BB E5 70 2B 10 08 04 02 C1 06 C9 00
Programming UROW...And it comes back with 'Failed to Program UROW'
I did find just before the firmware corrupt that the chip was getting hot, I have seen Deadlyfoez post regarding pins 13+14 on the ribbon cable, and tried this, but it seems to make little difference for reloading the firmware on the Infectus.
Any suggestions would be great.
TIA
