I'm not sure what I'm missing here. I have Acekard 2.1, with SDHC card, and with akaio 1.9 installed on it, and Warioware D.I.Y. is the only game that doesn't work. Whenever I load it, I get the "FAT error" message. All other games work fine, so it can't be a defective card, right?
The wiki suggested trying all of the other DMA modes, but I tried that and it doesn't seem to work. I'm confused about this and wondering if I'm doing something wrong. It says immediately after pressing A to launch the game, then you hold either X or A and the "Loading" text should be either green or red instead of the default yellow. However, when I try this, the text is always yellow. It seems like this option to change DMA mode isn't even available anymore in the latest firmware?
Other than that, I am all out of ideas. Can anyone confirm that Warioware DIY does in fact work on Acekard 2.1 with the latest firmware?
The wiki suggested trying all of the other DMA modes, but I tried that and it doesn't seem to work. I'm confused about this and wondering if I'm doing something wrong. It says immediately after pressing A to launch the game, then you hold either X or A and the "Loading" text should be either green or red instead of the default yellow. However, when I try this, the text is always yellow. It seems like this option to change DMA mode isn't even available anymore in the latest firmware?
Other than that, I am all out of ideas. Can anyone confirm that Warioware DIY does in fact work on Acekard 2.1 with the latest firmware?
