I'm stumped. Unless you're missing a step or doing something wrong, this really should work by now.
Assuming you did the step correctly and are using the Agent under fire method it should take only a couple of seconds till you see the ulauch menu.
Have you patched your ISO with ESR patcher? I had the same problem as you until i patched the ISO, burned it and then it worked. And if so, is it the lastest version?
I'm stumped. Unless you're missing a step or doing something wrong, this really should work by now.
If it reads retail discs fine, quick and with no stutter, it should probably read burnt ones as well.it may be possible i used the wrong solution to clean the lens. I gently rubbed with a q tip dipped in rubbing alcohal for first aid
it may be possible i used the wrong solution to clean the lens. I gently rubbed with a q tip dipped in rubbing alcohal for first aid
If it reads retail discs fine, quick and with no stutter, it should probably read burnt ones as well.
What exactly do you see upon booting the driving level (second level) from the menu? The screen goes black and that's it? When do you swap? Do you give the PS2 a moment to detect the disc? Are there any messages on-screen? Does the burnt backup disc spin as the "level" loads?
After completing the first level you then return to the menu. From there you take out the disc (it should stop the game but will still show it) and then swap with the burnt disc and it should run as normal, does this happen.
Can you previde screen shots or better yet, a video on this process. This is strangely weird as to why this isn't working.yes but the music will stop playing
Can you previde screen shots or better yet, a video on this process. This is strangely weird as to why this isn't working.
ill see if i can make a video but its going to have to be really low quality
There's the video you were asking for
Sorry that it's upside down there at the end
Try running the iso on a ps2 emulator. If the iso was patched correctly no doubt about it that it should work on pcsx2.
it runs fine on pcsx2. I downloaded a save game and imported it to the mem card image and I ran the second level and ulaunch came up. There's either a problem with the ps2 itself, the swap, or the burner I used
Remove your USB stick and try again, perhaps uLaunchELF has problems mounting it (which would make it the black screen culprit). Re-try the swap (which you are performing correctly) without the stick inserted to see if the ELF actually launches.
I guess you'll just have to rinse and repeat. It's odd that you're running into those issues, but don't worry - worst case scenario you can always mail your memory card to someone who already has FreeMCBoot and ask that person to perform a Multi Install for you and send the card back. You could also use another PS2.nope, that's not it. I'll just try a new dump